Specs & Fitment
All of our bodies are made to designed to match the Axial SCX24 Chassis and wheelbase.
All SWB bodies will fit great on your JLU, C10, Bronco, Deadbolt SCX24 Chassis
All LWB bodies will fit great on your gladiator chassis
Mounting our bodies to your rig couldn't be made any easier with our very own magnetic body mounts!
Mounting your Iceberg RC Body
Follow the simple steps below to mount your body to your rig using our Magnetic Body Mounts!
Step 1
Ensure you have all included parts ready to go!
- Mount set
- Magnets
- Double sided tape
Things you'll need:
- Super Glue or similar
- Knife or similar
Step 2
Separate all pieces from the base plate
- Use a knife or flat blade to separate all pieces from the base plate
Clean up the cups
- Use a knife to remove the stray plastic inside the magnet cups, in order to get flat surface
Step 3
Shave the very ends of the supports
- Use a knife to shave or the ends of the supports that will insert into the bottom of the cups
Attach cups to supports
- Place cups face down
- Insert the supports into the cups
Step 4
A few drops of Glue
- Place a few drops of glue into the top side of the cups
- Insert a magnet in each cup
ENSURE ALL MAGNETS ARE PLACE IN THE SAME ORIENTATION IN EACH CUP
Step 5
Install Mounts
- Insert the mounts into the shock towers
- Use the screws from the stock body mounts as grub screws
Remaining Magnets
- Place the remaining Magnets onto of the mounts
Step 6
Almost done
- Cut the included 3M double sided foam tape into 4 sections
- Clean the top surface of the magnets
- Place tape on top of each magnet
- Apply light pressure to tape for 1 minute
- Remove remaining tape protection
Final Step
Place the body on your Mounts
- hold the body above your rig
- ensuring it's straight, front to back and side to side
- lower the body and place on the mounts
- Apply light pressure on the body where it meets the magnets
DO NOT REMOVE BODY FOR AT LEAST 5 MINUTES
Job Done!
Removing the body
MAKE SURE TO SLIDE THE BODY SIDEWAYS TO TAKE IT OFF YOUR RIG!
